Operation - CONGA Cecotec 3690 Bedienungsanleitung

FIRST CLEANING
Once the robot and the charging base are completely installed, follow these steps before
scheduling the first cleaning cycle.
First of all, the robot must be fully charged. It is suggested to allow the robot to charge
overnight. When it is fully charged, it may carry out the first cleaning cycle and save the first
map. To do so, activate Auto cleaning mode and Eco power level. It is very important to follow
these indications for the robot to recognize each and every corner in the house and to create
a complete map.
If the house where the robot is going to be used is too big and the robot runs out of battery, do
not worry. The robot returns to the charging base, saves the full map and those that have not
been completed, and once it is charged again, it resumes the cleaning cycle from the point it has
stopped until it maps 100 % of the surface. The robot keeps on mapping constantly, therefore
it adapts independently to each house's features and improves previous maps continuously.

5. OPERATION

• Once the robot's light indicator changes from blinking yellow to steady blue, the battery is
fully charged and the robot is ready to operate.
• The robot cannot operate with low battery.
Recommendation: Remove all cables and obstacles from the floor before operating the robot
in order to avoid accidents and damage.
5.1. ROBOT BUTTONS
1. Auto mode
Press on the robot for it to start cleaning automatically, first a cleaning cycle in Edge mode
and then another cycle in and organized zig zag motion, recognizing which areas it has cleaned
and which ones it has not.
The robot will plan the cleaning route automatically as it is cleaning. If during this mode the
robot is controlled manually, the robot will calculate the route again and could go through
previously cleaned areas. In order to ensure efficient cleaning, do not operate it manually
during auto mode cleaning.
ENGLISH
29