Remote Control - CONGA Cecotec 3690 Bedienungsanleitung

ENGLISH
Thanks to its TotalClean 2.0 technology, if the battery is low during the cleaning cycle, the
robot will smartly return to the charging base automatically and, once it is fully charged, it will
resume the cleaning process from the same point, offering a high-efficiency cleaning.
During cleaning, the robot will stop briefly to evaluate the area and calculate the cleaning
route (this stop will vary depending on the house conditions).
Warning: The robot cleans in an organized way and per squared 4 x 4 m areas, therefore it
might leave the room where it is cleaning to finish off the delimited area. Do not worry about
this, the robot will clean all the accessible surface.
2. Back-home mode
Press the button on the robot in order to send the robot to the charging base. This mode can
be activated during any other cleaning cycle and the robot will stop cleaning and return to the
charging automatically.
The robot will take the shortest route back to the charging base thanks to its map memorizing
and its smart back-home function.
When a cleaning cycle has been completed or the robot's battery is low, the robot will also
return to the charging base to avoid running out of battery.
Recommendation: remove the Wet & dry tank during charge.
5.2.

REMOTE CONTROL

1
2
• The following operations and modes can be activated from the remote control.
30
1. Schedule
2. Power levels (Turbo/Normal/Eco)
3. Back home
4. Time
4
5. Manual control
5
6. On/Pause
6
7. Edge mode
7