CONGA Cecotec 3690 Bedienungsanleitung Seite 28

ENGLISH
WET & DRY TANK INSTALLATION
Note: it is not suggested to use the scrubbing function for the first-time use.
1. Open the tank's rubber lid, fill the tank with water carefully so water
does not come out. Make sure the silicone clip is properly closed to avoid
water from spilling.
2. Install the tank in the robot following the directions indicated in the
Note:
• Do not use the scrubbing function while the robot is unattended.
• Remove the mop bracket when the robot is charging or not in use.
• If there are carpets in the house, set Restricted Areas to avoid the robot from passing
over them.
• Add some drops of cleaning agent (not corrosive) if considered necessary.
Warning: the excess of cleaning agents might block water outlets.
5. To remove the mop bracket, press the release button and pull from it outward.
28
drawing. Make sure the clip is properly fastened.
3. Only for Wet & dry tank installation:
Attach the mop to the bottom part of the mop bracket with the Velcro.
4. Manually press the clips on both sides of the mop bracket and push it
into its correct position until you hear a click indicating it is properly fixed.
Warning: in order to achieve perfect scrubbing, it is suggested
to moisten the mop before using it.