Operation - CONGA Cecotec 3290 Bedienungsanleitung

5. OPERATION

• Once the robot's light indicator changes from blinking orange to steady blue, the battery
is fully charged and the robot is ready to operate.
• The robot cannot operate with low battery.
Recommendation: Remove all cables and obstacles from the fl oor before operating the robot
in order to avoid accidents and damage.
ROBOT BUTTONS
1. Auto mode
Press on the robot for it to start cleaning automatically, fi rst a cleaning cycle in Edge
mode and then another cycle in and organized zig zag motion, recognizing which areas it has
cleaned and which ones it has not.
The robot will plan the cleaning route automatically as it is cleaning. If during this mode the
robot is controlled manually, the robot will calculate the route again and could go through
previously cleaned areas. In order to ensure effi cient cleaning, do not operate it manually
during auto mode cleaning.
Thanks to its TotalClean 2.0 technology, if the battery is low during the cleaning cycle, the
robot will smartly return to the charging base automatically and, once it is fully charged, it
will resume the cleaning process from the same point, offering a high-effi ciency cleaning.
During cleaning, the robot will stop briefl y to evaluate the area and calculate the cleaning
route (this stop will vary depending on the house conditions).
Warning: The robot cleans in an organized way and per squared 4 x 4 m areas, therefore it
might leave the room where it is cleaning to fi nish off the delimited area. Do not worry about
this, the robot will clean all the accessible surface.
2. Back-home mode
Press the button on the robot in order to send the robot to the charging base. This mode
can be activated during any other cleaning cycle and the robot will stop cleaning and return
to the charging automatically.
ENGLISH
27