CONGA Cecotec 3290 Bedienungsanleitung Seite 25

WARNING: do not expose the charging base to direct sun light.
3. Long press the
robot on the charging base.
Note:
• Take the robot to the charging base if the battery is low. The robot might not turn on if
the battery is very low.
• The robot will automatically turn on when placed on the charging base.
• The robot cannot be turned off during charging.
WET & DRY TANK INSTALLATION
Note: it is not suggested to use the scrubbing function for the fi rst-time use.
1. Open the tank's rubber lid, fi ll the tank with water carefully so
water does not come out. Make sure the silicone clip is properly
closed to avoid water from spilling.
Drawin Conga 3290-3490.pdf 1 13/5/19 9:54
2. Install the tank in the robot following the directions indicated in the drawing. Make
sure the clip is properly fastened.
3. Attach the mop to the bottom part of the mop bracket with the
Velcro.
4. Manually press the clips on both sides of the mop bracket and
push it into its correct position until you hear a click indicating it
is properly fi xed.
button for 3 seconds; when the light indicator turns on, place the
• Steady blue light: ON/operating
• Orange light oscillates: charging
• Red light blinks: error
ENGLISH
C
1.
2
3
4
5
6
7
8
9
D
1.
2
3
4
B
1.
2
3
4
5
25