Technical Data - SUHNER ABRASIVE LGS 30 Gebrauchsanleitung

Technical Data

at 90 PSI Operation Pressure
Stroke (Frequency)
Air consumption
no load
Sound pressure level
according to CEN/TC 255 N
Vibration according to
ISO/DIS 8662-4
Weight with hose
Recommended air quality
according to DIN ISO 8573-1
Air hose ID
Lenght of hose
Air connection
Machine components:
1 Cover
2 Housing
3 Valve ring
4 Hose nipple clip
5 Air hose
6 Hose nipple
7 Spring
8 O-ring
9 Connection
Recommended Accessories
10 Coupling with min ID 3 mm/1/8"
11 1/4" - Service Unit ( Capacity 5-
8 Micron).
Suitable Tools:
12 Stylus points fine/medium/coarse
Can be found in the the SUHNER catalogs.
LGS 30
ca. 30000 pm
7,0 cfm
3
0,03 m /min
62 dB(A)
2
< 2,5 m/s
0,15 kg
3/4/4
4 mm/1/6"
2,0 m
G 1/4"
Accessories set for chisel
8 O-ring
13 Chisel flat
14 Chisel pointed
15 Spring
16 Cover
17 Fixing device for spring 15
Air supply requirements:
The DIN ISO quality specifications require, that
air is free of solid particles larger than 5
micron, remaining water content to be max. 6
3
g/m (pressure dew point+3 degree C) and
air may contain 5 mg/m
please observe the following:
• Operating with dirty and unlubricated air
reduces tool life substantially.
Before installing extension hoses, blow them
clean and minimize , if at all necessary
coupling and keep them clean.
• Conserve:
Put some drops of oil in the air inlet and briefly
blow through.
Safety Instructions:
• Observe accurate mounting of stylus points.
• If noise level exceeds 85 dB(A) at the work
station, operator must use ear plug and/or ear
mufflers.
Operation conditions and instructions
Throttle action
• Ring throttle action and also regulated as
illustrated in manual.
Marking/Chisel
• Observe even material removal, avoid
chattering.
•If the pen stops at a "dead point" and will not
start, it can be set going by gently tapping the
stylus.
GB
3 of oil. Therefore