Using The Optional Fiber Optic Module; Installing.and.activating.the.fiber.optic.module - Stryker WiSe Bedienungsanleitung

Using the Optional Fiber Optic Module

The display features an optional optical module accessory (0240030962), which
allows it to receive a high-definition video signal over fiber optic cables.
Installing and Activating the Fiber Optic Module
Caution Excessive force or misalignment during insertion might damage
the module connector.
1. Power off the display using the hard power switch.
2. Unscrew the two screws from the cover plate, then remove the cover
plate.
3. Insert the Fiber Optic Module into the Fiber Optic Module slot and
screw into place.
4. Power on the display using the hard power switch.
5. Power off the display using the soft power switch.
6. Press and hold the soft power switch on the display for 10 seconds to
activate the Fiber-Optic input from the Input Selection menu.
Input Selection List
Digital RGB
Wireless RGB
Analog RGB
Digital Optical*
*Greyed out if module is not installed
18
1
1. Power Switch (hard)
2. Power 24V
3. Optical Module Slot with Cover Plate
HD/SD-SDI
Component (Y/Pb/Pr)
RGBS
S-Video
2 3
C-Video
SOG
Exit