Stryker WiSe Bedienungsanleitung Seite 27

1. Power on the transmitter and auxiliary display. The token LED shines
amber as the units perform startup functions.
2. Insert the token into the token slot on the transmitter. The token LED
also shines amber as it writes the data.
3. When the token LED turns green, remove the token from the transmitter.
4. Within 2 minutes, insert the token into the token slot on the auxiliary
display. An audible tone will sound from the transmitter and the token
LED will change from amber to green when the display and transmitter
have been linked.
5. Remove the token from the token slot on the auxiliary display.
6. By repeating steps 4 and 5, as many as two additional auxiliary displays
may be linked. All linking must be done within two minutes.
7. Store the token in the transmitter token slot when not in use.
Note If multiple transmitters are within 100 feet of each other, for example,
in adjacent operating rooms, link each transmitter to its respective
display(s) one set at a time. Wait 15 seconds before linking the next
transmitter/display set.
HDTV TRANSMITTER
23