Dcf Signal; Connecting With The Outdoor Sensor - BEARWARE 302670 Bedienungsanleitung

Note: The backlight is not constantly on. The display lighting is switched
on when the motion sensor detects a movement at the top of the device.

6 DCF signal

The DCF signal is a time signal, which is sent out by one of the most accurate clocks
in the world. It is located near Frankfurt am Main. Under ideal conditions, your
weather station can receive this signal from a distance of up to 1500 km.
If the weather station has detected the signal, then it displays Central European
Time, the date, and the day of the week. The DCF symbol " " is then shown in
the display.
If the attempt to receive a signal fails, then the weather station stops searching
after about 7 minutes. The DCF symbol disappears from the display.
Re-activate the search by pressing the "Down" button for about 3 seconds until the
DCF symbol is shown once again in the display. You can cancel the manual search
by pressing the "DOWN" button again for about 3 seconds during the search.
Alternatively, you have the option of manually setting the time. Further informati-
on on this topic can be found in the "Basic settings" section.

7 Connecting with the outdoor sensor

Make sure that both the devices are within each other's range. The connection
symbol " " flashes in the "Outdoor temperature display" of the main unit. If
the main unit cannot establish a connection with the outdoor sensor within 3
minutes, then it stops searching. The connection icon stops flashing and the tem-
perature display shows "--.° C" in the display. Ensure that the switch in the battery
compartment of the outdoor sensor is set to the desired channel.
In most cases, the connection cannot be established due to specific factors such as
reinforced walls or a too great distance between the sensor and the main unit. In
this case, position the sensor and the main unit closer to each other.
English
17