Basic Settings - BEARWARE 302670 Bedienungsanleitung

C and ° F. This can be changed by pressing the "DOWN" button.
The measured value should not be below the minimum value (0°) or above the
maximum value (50°C).
Outdoor temperature display:
The outdoor temperature is measured by the outdoor sensor and shown with an
accuracy of one tenth of a degree. The configured temperature unit is displayed
to the right of the measured value. The temperature unit can be changed bet-
ween ° C and ° F. This can be changed by pressing the "DOWN" button.
The measured value should not be below the minimum value (-40°) or above the
maximum value (60°C).

9 Basic settings

Note: Any movement above the motion sensor on the top of the housing will
switch on the backlight. Please note that the base station does not respond
to 2 buttons at the same time. It is therefore advisable to press only one
button.
Press and hold the "SET" button in time mode for about 3 seconds to configure
the basic settings. With the "UP" and "DOWN" buttons you can change the values
accordingly.
By briefly pressing the "SET" button in the time settings, you can confirm entry
and proceed to the next option. In this way, you can change and customise the
following settings in the sequence mentioned below:
• 12/24 hour display
• Time zone- Note: If you set the time zone, for example, to + 01
and the weather station is actuated using the DCF-signal, then the
clock displays one hour later than the DCF-signal.
• Hours
• Minutes
• Language setting- To set the day in the display. The following
codes can be configured and selected using the "UP" and "DOWN"
buttons: GER (German), DAN (Danish), ESP (Spanish), NET (Dutch),
FRE (French), ITA (Italian), ENG (English)
English
19