Mounting Or Removing Of Pushbar - Vermeiren D200 30 Gebrauchsanweisung

2.2

Mounting or removing of pushbar

L WARNING:
Risk of injury - Make sure that the starknobs Ⓐ are tightened.
L WARNING:
Risk of injury - When equipped with the pushbar, the pushbar shall
always be mounted (→ to increase the stability of the backrest).
The mounting of the pushbar Ⓑ is done as follows:
1. Mount the pushbar Ⓑ with the starknob Ⓐ in the left handgrip.
2. Swing the pushbar Ⓑ to the right.
3. Mount hook Ⓒ over the right handgrip Ⓓ as shown on the drawing. Use holes  or  to
adjust the tension of the backrest.
To take off the pushbar:
1. Loosen the starknob Ⓐ on the right handgrip.
2. Remove hook Ⓒ from the right handgrip Ⓓ.
1. Pull lever  on both sides towards the
handgrip  to adjust the backrest.
2. The pin Ⓐ comes out the groove of the toothed
plate Ⓑ.
3. Pull both back tubes backwards continuously
to the desired position (4 different positions: 5°
- 15° - 25° - 35°).
4. Check that the pin Ⓐ is well fixed in the groove
of the toothed plate Ⓑ.
If your wheelchair features drum brakes, the levers
 are used as brakes.
(add to manual D200)
Page 3
D200 30°
2014-10