Technical Data; Installation - Zanussi ZFU719EW Benutzerhandbuch

Problem
The appliance does not cool at
all
Green indicator flashing
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated in-
door (garage or cellar) also, but for optimum performance
install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Possible cause
Plug is not connected to the mains
socket properly
There is no voltage in the mains sock-
et (try to connect another appliance in-
to it)
The appliance is not switched on
Temperature Regulator is not on
Temperature sensor problem
Height
Width
Depth
Connect the mains plug properly
Call an electrician
Switch on the appliance
Check the Temperature Regulator
Call the service personnel
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
1250 mm
545 mm
640 mm
18 h
230 V
50 Hz
Climate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rear spacers
In the bag with the documentation, there are two spacers
which must be fitted as shown in the figure.
Solution
Ambient temperature
9