Preparing For Use; Filling The Water Tank; Setting The Temperature - Philips Mistral GC2425 Bedienungsanleitung

Place and use the iron on a stable ironing board or table.
If a stand is provided with the appliance, ensure that the stand is
placed on a stable surface.
This appliance is intended for household use only.

Preparing for use

Filling the water tank

1 Remove the mains plug from the wall socket.
C
2 Set the steam control to position O (= no steam).
3 Open the filling cap (specific types only).
C
4 Tilt the iron and fill the water tank up to maximum level.
Do not fill the water tank beyond the MAX indication.
5 Close the filling cap (click!) (specific types only).
If the tap water in your area is very hard, we advise you to use distilled
water. Do not use vinegar, starch or chemically descaled water.

Setting the temperature

The iron may give off some smoke when you use it for the first
time.This will cease after a short while.
C
1 Put the iron on its heel and set the temperature dial to the
required ironing temperature by turning it to the appropriate
position.
- Check the garment label for the required ironing temperature.
- 1
Synthetic fabrics (e.g. acrylic, viscose, polyamide, polyester)
- 1
Silk
- 2
Wool
- 3 Cotton, linen
- If you do not know what kind or kinds of fabric an article is made of,
determine the right ironing temperature by ironing a part that will
not be visible when you wear or use the article.
- Silk, woollen and synthetic materials: iron the reverse side of the
fabric to prevent shiny patches. Avoid using the spray function to
prevent stains.
2 Put the mains plug in an earthed wall socket.
ENGLISH
7