Preparing For Use; Filling The Water Tank; Setting The Temperature - Philips GC4444 Bedienungsanleitung

EnGlish
8

Preparing for use

Filling the water tank

1 Make sure the appliance is unplugged.
 Set the steam control to position 0 (= no steam) (Fig. ).
 Open the cap of the filling opening.
 Tilt the iron backwards and fill the water tank with tap water up to
the maximum level by means of the filling cup. (Fig. 3)
Do not fill the tank beyond the MAX indication.
Do not put perfume, vinegar, starch, descaling agents, ironing aids or
other chemicals in the water tank.
If the tap water in your area is very hard, we advise you to mix it
,
with an equal portion of distilled water, or to use distilled water
only.
5 Close the cap of the filling opening ('click') (Fig. 4).

Setting the temperature

1 Type GC/GC0 only: remove the heat-resistant protective
cover (Fig. 5).
Do not leave the heat-resistant protective cover on the soleplate
during ironing.
 Put the iron on its heel and set the required ironing temperature
by turning the temperature dial to the appropriate position (Fig. 6).
Check the laundry care label for the required ironing temperature:
- Synthetic fabrics (e.g. acrylic, nylon, polyamide, polyester)
1
- Silk
1
- 2 Wool
- 3 C otton
- MAX linen
If you do not know what kind or kinds of fabric an article is made of,
determine the right ironing temperature by ironing a part that will not be
visible when you wear or use the article.