NEC MultiSync XV17 Handbuch Seite 23

E-18
Basic Geometry Controls Menu
The Basic Geometry controls allow you to adjust the curvature or angle
of the sides of your display.
Sides In/Out (pin cushion): increases or decreases the curvature of the
sides either inward or outward.
Sides Left/Right (pin cushion balance): increases or decreases the
curvature of the sides relative to each other.
Sides Tilt (parallelogram): increases or decreases the tilt of the sides
either to the left or right.
Sides Align (trapezoidal): increases or decreases the top of the screen
to be the same as the bottom.
While in the Basic Geometry Controls Menu, the buttons on the front of
the monitor work as follows:
exit: exits to the main menu.
control up/down: moves the highlighted area up/down to select one of
the choices.
control +/-: moves the bar in the + or - direction to increase or decrease
the adjustment.
proceed: proceeds to the controls in that sub-menu
reset: resets the current highlighted control to the factory setting.
Note: a warning window will allow you to choose to reset the current
control or to cancel reset of the current control.
Basic Geometry
Sides:
In/Out
Left/Right
Tilt
Align
OSM Menus