Silvercrest SWKK 2400 A1 Bedienungsanleitung Und Sicherheitshinweise Seite 33


Place the base (6) on an even, non-slip and dry surface. Note that the power cable (7) must be
fed through one of the notches provided on the underside of the base (6) to ensure stable
positioning.
WARNING
If the power cable (7) is not fed through one of the notches provided on the
underside of the base (6), the base (6) and kettle (3) will not be stable. The
movement of the boiling water could make the kettle tip over causing severe
damage to property and personal injury!

Open the lid (11) by pressing the lid release button (10).
To avoid leakage of any condensation, the lid (11) opens about two thirds
only. It is possible to slightly increase the aperture angle of the lid (11). To do
so, carefully press the lid (11) open a bit more until its end position has been
reached.
"Minimum fill level" indicator
The minimum water fill level is 0.5 litres.
This low level is not visible on the outer
water level indicator (4).
A special mark indicating the exact
minimum fill level can be seen inside
the kettle (3) while filling with water.
This mark inside the kettle (3) is visible
when the lid (11) is open. An additional
mark indicates approx. 0.7 l of water.

Fill the kettle (3) with drinking water, at least up to the "MIN 0.5L" mark inside and up to the
"1.7L MAX" mark on the water level indicator (4) and close the lid (11) by pressing it down
until it clicks into place.
When the kettle (3) is placed on the base (6), it can be freely rotated 360°
around the vertical axis. It does not need to engage in a certain position. This
allows you to rotate the kettle (3) such that you can easily check the water level
indicator (4) and rotate the kettle (3) so that the steam is directed away from
you.

Plug the mains plug into an easily accessible mains socket.
SilverCrest SWKK 2400 A1
English - 31