Oki LE840 Serie Handbuch Seite 36

2. PRINTER SETUP
2.6.2 Parameter Setting
(Cont.)
(15) XML
Select the type of XML data to be printed.
 OFF
Disables XML data printing.
 STD
Standard specification
 ORACLE
Oracle
 SAP
SAP
 STD EXT
Standard specification (External memory)
 ORACLE EXT Oracle using an external memory
 SAP EXT
SAP using an external memory
(16) THRESHOLD SELECT
This parameter is to choose which threshold value for the media
sensor to validate.
 REFLECT
Reflective sensor (Black mark sensor)
 TRANS.
Transmissive sensor (Gap sensor)
Then, choose which value to use.
 MANUAL SET
 COMMAND SET
(17) ENERGY TYPE
This parameter is intended to make the printer perform appropriate
printing for the supplies to be used. If you use a different supply from
the setting, poor printing may occur.
 TRANSFER
Thermal transfer print method → 
 DIRECT
Thermal direct print method → 
 When TRANSFER is selected for the Energy type parameter,
choose a ribbon type.
 Wax1
 Wax2
 Wax3
 Semi resin1
 Semi resin2
 Semi resin3
 Resin1
 Resin2
 Reserve1 to Reserve2
 When DIRECT is selected for the Energy type parameter
 Standard
 Reserve1 to Reserve9
E2-22
Threshold set in the Threshold mode takes
effect.
Threshold set by command takes effect.
Wax 1
Wax 2
Wax 3
Semi-resin 1
Semi-resin 2
Semi-resin 3
Resin 1
Resin 2
Reserved
Standard
Reserved
2.6 Printer Setting