Oki LE840 Serie Handbuch Seite 31

2. PRINTER SETUP
2.6.2 Parameter Setting
(Cont.)
NOTE:
Underlined setting is the factory
default.
NOTE:
1. If the pitch of the media used for
the previous issue was less than
20mm, the forward wait will not
be activated regardless of the
parameter setting.
2. The media will stay at the
forwarded position even if the
power is turned off/on, the printer
is reset, the print head is
opened/closed.
2.6.2.1 Printer Set
(1) MEDIA LOAD
Determines how the use of the [FEED] key enables the printer to
detect the home position. This parameter is effective only when the
sensor type is set to other than "None".
 OFF
 STD
 ECO
 ECO+Bfeed
(2) FORWARD WAIT
This parameter allows you to choose whether or not to activate the
auto forward wait function. This function, used in the cut mode,
automatically feeds the media forward if there is more than a 1-second
idle time after printing. This prevents the top edge of the media from
curling.
 OFF
 ON
 When ON is selected, the feed amount can be fine adjusted.
(3) FORWARD WAIT POS.
+5.0mm
+4.9mm
-4.9mm
-5.0mm
.
E2-17
Media loading function is disabled (Same as a feed
by [FEED] key)
When the [FEED] key is pressed after the printer is
tuned on, reset in batch mode, or the print head is
closed, the printer detects the next gap/black mark
and feeds the paper from the sensor to the print start
position.
When the [FEED] key is pressed after the printer is
tuned on, reset in batch mode, or the print head is
closed, the printer detects the next gap/black mark
and feeds the paper to the print start position based
on the last label pitch printed.
Since optional ribbon saving module is not
available to the LE840/LE850, MEDIA LOAD
setting and the printer
automatically changed to "ECO" setting even if
"ECO+Bfeed" is selected for these models.
Disables the auto forward feed wait
Enables the auto forward feed wait → 
(Default: 0.0mm)
2.6 Printer Setting
behavior will be