G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; Ec Declaration Of Conformity - SUHNER ABRASIVE LBC 16-TOP Originalbetriebsanleitung

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LBC
16-TOP.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with burrs and abrasives.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner AG, Industriestrasse 10, CH-5242 Lup-
fig, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side)
complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: T. Fischer. CH-Lupfig, 11/2019.
T. Fischer/Managing Division manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Si raccomanda aria compressa oleosa(see
also air quality under section 2.3). Ob-
serve national regulations.
Check the grinding belt before use. The driver roller must
be installed centrally and aligned to the stop. Under no
circumstances must the grinding belt exceed the max
permitted speed. Observe national regulations. Take pro-
tective measures when dust can develop during working
that is harmful to one's health, cumbustible or explosive.
Wear a dust mask and work with dust/chip extraction
when connectable
22
s
otes on aFety
ommIssIonIng
2.2 t
AKing the mAchine into serVice
2.2.1 t /t
urn on urn off
Tilt lock forward and press lever on plastic sleeve. Releas-
ing the lever will shut the machine down.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No-load speed
Sound pressure level EN ISO 15744 83dB(A), K=3dB(A)
Noise emission level EN ISO 15744
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight
Grinding belt and non woven:
Belt length
Belt width
Belt thickness
Belt tension
Belt speed
Drive roller
2.4 o

PerAting conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3.
handlIng
3.1 g
rinding Belts
Use grinding belts only whose
max permitted speed is equal to or
higher than the machine's idle belt
speed!
Install clean grinding belts only.
max. 6.3bar
330W
0.65m /min
3
0.79m /min
3
about 3-4 drops/min
18000min
-1
94dB(A), K=3dB(A)
0.91m/s , K=0.59m/s
2 2
3/4/4
1.230kg
520mm / 20 1/2"
3-19mm / 1/8"-3/4"
up to 4mm
40-90N
28m/s
Ø 30mm
/ o
PeratIon