NORAUTO NS-X800BT Bedienungsanleitung Seite 371

4. Complete wiring as illustrated in the wiring diagram. Once
the wiring is complete, reconnect the battery negative
terminal. If there is no ACC available, connect the ACC lead
to the power supply with a switch.
CAUTIoN! Be careful not to damage the car wiring
5. After completing the wiring connections, turn the unit on to
confirm operation (ignition switch must be on). If unit does
not operate, recheck all wiring until problem is corrected.
Once proper operation is achieved, turn off the ignition
switch and proceed with final mounting of the chassis.
a. Connect wiring adapter to existing wiring harness.
b. Connect antenna lead.
c. Carefully slide the radio into the half-sleeve, making sure it
is right-side-up. Use the supplied screws to attach the radio
to the half sleeve.
Using the Cosmetic Trim Ring
One cosmetic trim ring is packaged with the head unit for
installation flexibility. This unit will fit into most import dashes
with little or no modification to the dash board/cavity. Some US
domestic vehicle dashes will accept a Double-DIN chassis, but
there is usually a small gap between the radio and dash piece
after installation is complete. In this case, use the trim ring to
conceal any gaps that may be present.
369