Installation - NORAUTO NS-X800BT Bedienungsanleitung

INSTALLATIoN

disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and
remove the negative (-) battery cable prior to installation.
Note:
If the unit is to be installed in a car equipped with an on-board
drive or navigation computer, do not disconnect the battery cable.
If the cable is disconnected, the computer memory may be lost.
Under these conditions, use extra caution during installation to
avoid causing a short circuit.
Replacing the Fuse
When replacing the fuse, use a new 15A replacement fuse.
Using a fuse with an improper rating could damage the unit and
cause a fire.
Installation Using half-Sleeve
1. Install half-sleeve in the dashboard.
a. Install adapter if necessary (optional).
b. Install half-sleeve into adapter or dashboard (use only the
supplied screws). Do not force the sleeve into the opening
or cause it to bend or bow.
WARNING! only connect the unit to a 12-volt power supply
with proper grounding
c. Locate the series of bend-tabs along the top, bottom and
sides of the mounting sleeve. With the sleeve fully inserted
into the dashboard opening, bend as many of the tabs
outward as necessary so that the sleeve is firmly secured to
the dashboard.
2. Use the M5 x 6 screws (provided) to install the mounting
brackets to each side of the radio using the holes indicated
in the diagram. do NoT USE oThER SCREWS
3. Place the radio in front of the dashboard opening so the
wiring can be brought through the mounting sleeve.
368