Herunterladen Inhalt Inhalt Diese Seite drucken

Working Instructions; Vorbeugende Instand- Haltung; Preventive Maintenance - SUHNER ABRASIVE LBH 7-H35 Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Probelauf min. 30 Sekunden
ohne Belastung durchführen.
3.3
Arbeitshinweise
Bei Druckluftausfall ist der Ven-
tilhebel loszulassen!
• Zu starker Schleifdruck ver-
ringert die Leistungsfähig-
keit der Maschine und die
Lebensdauer des Schleif-
bandes.
• Vliesbänder müssen mit re-
duzierter Drehzahl betrieben
werden.
4.1
Vorbeugende Instand-
haltung
• Leerlaufdrehzahl periodisch
und nach jeder Wartung
kontrollieren.
• Selbst wenn die Maschine
noch einwandfrei arbeitet,
sollte durch eine Fachper-
son periodisch nach ca.
300-400 Arbeitsstunden,
jedoch mindestens einmal
jährlich der Motor ausge-
baut, gereinigt und die vier
Schieber auf Abnützung
geprüft werden.
16
DE
Effectuer un essai de 30 se-
condes minimum hors sollicita-
tion.
3.3
Indications de travail
En cas d'interruption de l'ali-
mentation en air comprimé,
relâcher le levier de soupape !
• Une pression de ponçage
trop importante diminue la
performance de la machine
et la longévité de la bande
abrasive.
• Les bandes en non-tissé
doivent être utilisées avec
une vitesse de rotation
réduite.
4.1
Maintenance préven-
tive
• Contrôler périodiquement
la vitesse de rotation à vide
sans introduction d'outil de
même qu'après chaque
opération de maintenance.
• Même si la machine fonc-
tionne encore parfaitement,
un spécialiste doit périodi-
quement (environ toutes les
300-400 heures de service
ou au moins une fois par
an) démonter le moteur, le
nettoyer et contrôler l'usure
des quatre vannes.
FR
Let the tool run without load for
at least thirty seconds.
3.3

Working instructions

On failure of the compressed air
release the valve lever!
• Too great a grinding pres-
sure reduces the machine's
performance and the ser-
vice life of the grinding belt.
• Nonwoven belts must
be operated at reduced
speeds.
4.1
Preventive mainte-
nance
• Without a tool clamped
in check no-load speed
periodically and after each
maintenance.
• Even if the machine still
operates perfectly, the
motor should be removed,
cleaned and the four slides
checked for wear by a spe-
cialist after approx. 300 to
400 operating hours.
GB

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Lbh 7 h50

Inhaltsverzeichnis