Tecfrigo SNELLÈ 750 GBT-R-VU Zusammenbau Und Betrieb Seite 6

Operator's guide:
1. Unpacking instructions
2. The handles
3. Round glass shelves
I
4. Grid shelves
5. Cleaning of the internal glass panels
UK
6. Connection to mains
7. Controls
D
8. Checking the correct functioning
9. Replacement of internalight
E
10. Replacement of the door magnetic gasket
11. Internal cleaning
F
!
WARNINGS
NL
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
P
1 . Adults should operate this appliance only. Do not allow children to use the controls or play with it.
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
S
installation of the appliance should be carried out by a qualified electrician or other competent person.
4
. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
DK
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs. 6
FIN
7 . The manufacturers of this appliance accept no responsibility for the consequences of misuse in
contravention of these safety instructions. It further reserves the right to carry out improvements without
8
prior notice.
B
near sources of heat, such as radiators, stoves, etc.
for at least 30 cm.
GR
edges. 12 . If damp air or products to be refrigerated should cause ice to form on the evaporator, we
recommend stopping the compressor and placing the goods in special refrigerated containers, kept at the
CZ
same temperature, until defrosting is completed;if this is not carried out the compressor will continue to
operate leading to a wasteful consumption of electricity and poor performance.
EE
working and unused, it is indispensable to keep the door open at least 10 cm. Avoiding this, you will avoid
also the consequent mildew formation and unpleasant smells.
LV
LT
! Our products are for internal use only do not install outside restaurants, shops.
H
M
1. UNPACKING INSTRUCTIONS
CARDBOARD BOXES 1a.
PL
WOODEN CRATES 1b.
containing the internal shelves (fragile!).
SK
crate. . Lift the appliance. 4
and make any adjustments with the special foot. .
SLO
the back of the appliance. . Make sure there is nothing left in the package before disposing of it. .Sort
out the packaging materials in order to facilitate disposal (see fig. 1).
2. THE HANDLES
1 . The handles can be found in a bag inside the appliance.
screws already inserted in the holes on the door post; wrench down the screws. . Place the plastic insert
over the handle and press down until it clicks into place (see fig. 2).
3. ROUND GLASS SHELVES
1 . These shelves, to be found in the cardboard box, should be slid into the supports placed in the vertical
rotating frame (first introduce the mirror shelf, in the lower position)
using the screws contained in the pack inside the appliance, with the plastic part towards the glass.
Tighten with care (see picture 3)
4. GRID SHELVES
The Ecodisplay models are supplied fitted with grid shelves. To remove a grid for replacing, cleaning or
position adjusting purposes:
sideways until it comes out of the panel on the opposite side.
opposite side
5
. Avoid installing the cabinet directly in line with sunlight. . Nevere install the appliance
11 . Ensure that the products displayed on the shelves and grills do not hang over the
Cut surrounding tape. Remove the cardboard package by sliding it upwards.
Remove the nails from the wooden crate with care. .
5 . Remove the pallet or crate. . Place the appliance on a flat, level surface,
8
R
Model
Ecodisplay
model
1. Remove the hooks that secure the grid to the side panels. . Push the grid
(b). 4 . Reassemble by following the above instructions in reverse order (see fig. 4).
Operator's guide
Maintenance manual (Page 48):
1. Cleaning the condenser
2. Cleaning the evaporator
3. Replacement of a glass panel
4. Wiring diagram diagram of refrigeration unit
10 . Keep the ventilation grills free from obstruction
3. Insert forks of forklift truck between the appliance and pallet or
6
7 Ecodisplay only:
2. Fix the base of the handle using the two
3. Tilt the grid
6
3
9
13 . If the appliance is not
2 Snellè only: remove box
put the two spacers in the holes on
3
2.
The shelves have to be fastened
2
(a) to take it out of the
2 . It
9