Cleaning And Maintenance - Chicco HUMI RELAX 06683 Handbuch

(3) reaches the minimum operating level,
the appliance will stop heating after a few
minutes, the on/off button (1) will remain
in the (I) position and the indicator LED (2)
will switch off. Switch off the appliance by
pressing the switch (1) to the (0) position
(Diag. E), disconnect the plug from the power
socket and refill the water tank as indicated
in the Preliminary Operations paragraph.
Warning: the appliance is fitted with
an automatic device that switches off the
heating element (10) used to produce the
steam when there is no water left in the tank
(3).
In order to start the steam dispenser again,
you must first switch the device off, wait for
the heating element to cool down enough
and then press the switch (1) to turn it back
on again.
Warning: never remove the lid cover
unit (8) before switching off the appliance
and disconnecting the power cable plug from
the mains socket.
To switch off the appliance, press the button
(1) to the (0) position (Diag. E).
Warning: when the appliance has
been switched off, the water contained in
the heating tank (10) could continue to boil
for some minutes.
WARNING: if the outer surfaces
(including the base) of the product are wet
after filling or emptying the tank, dry them
immediately with a clean cloth before
plugging the cable into the mains and
switching the appliance ON.

CLEANING AND MAINTENANCE

Warning!!
Before carrying out the following cleaning/
maintenance operations, always switch off
the appliance; first disconnect the power
cable plug (11) from the mains socket and
then allow the appliance, the adjustable
nozzle and the extractable lid to cool down
completely.
How to clean the water tank, the heating
tank and the lid
During normal operation, the salts contained
in the water could cause the formation of scale
residues in the steam duct and heating tank
(10). The formation of scale residues could
take place more or less quickly, depending on
the type of water, its hardness and frequency
of use of the appliance. The harder the water,
the quicker the formation of scale residues.
Scale residues decrease performance and
could compromise the normal functions of
the appliance. It is therefore recommended
to descale the appliance, at least once a
week, as indicated below:
1. use the hand grip (9) to open the lid (8).
2. remove the steam duct from its seat inside
the tank by turning it clockwise.
3. Fill the water tank with cold drinking
water.
4. Rinse it out several times allowing the
water to flow through the holes at the back
of the appliance (12), making sure you do not
wet the power cable (11) (Diag. H).
5. Clean the heating unit (water supply duct,
heating tank and resistor) (10), seated in the
middle of the tank (Diag. G) removing all
scale residue.
6. After removing any residual water, mix
about 1 litre of water and 1 litre of white wine
vinegar together and pour it into the water
tank (3); fit the lid cover (8) back on the tank
(3), wait for about 4 hours then shake the
appliance for a few minutes and repeat the
procedure indicated in Part 2. Now empty
the tank (3) and remove any scale residue
with a cloth; use plenty of drinking water
to rinse the tank (3), the unit lid (8) and
the removable water supply duct and the
heating tank (10). Leave the tank (3) and lid
(8) to drain and dry thoroughly with a soft
cloth; then replace the steam duct (10) and
the lid (8).
7. Dry the outside of the appliance by gently
16