Safety And Maintenance - Chicco Humi3 Anleitung

Warning!
Always use cold previously boiled drinking
water (allow the boiling water to cool to at
least 40°C) to fill the water tank/container for
normal use and to perform daily and weekly
cleaning of the appliance, as described in the
instructions for use. This will prevent the proli-
feration of germs and bacteria.
INSTRUCTIONS FOR USE
Preliminary operations and functions
• Check that the appliance is perfectly clean,
that the on/off switch (2) is in the O – OFF
position and that the AC/DS mains adap-
tor (7) plug is disconnected from the mains
(Diag. A)
• Lift the nebulising unit (transducer) (6) using
the handle grooves (8) (Diag.B).
• Fill the water tank (5) with cold boiled drin-
king water up to MAX level indicator (9)
(Diag.C).
WARNING: used cold boiled drinking
water only, never use other liquids or substan-
ces. Never add any aromatic oils to the water
contained in the tank (5), as the appliance
could be damaged permanently.
• Replace the nebulising unit (transducer) (6)
on the water tank (5).
• Place the appliance in the selected area, at about
70 – 100 cm from the floor, following the indica-
tions specified in the Warnings paragraph.
• Connect the AC/DC main adaptor (7) cable
plug to the main adaptor connecter on the
appliance (Diag. D), then connect the AC/DC
mains adaptor (7) plug into the mains socket
• Turn the on/off switch (2) to "I" – ON; the
light blue appliance ON (1) indicator will
come on (Diag. E) and the nebulised water
will start to be expelled from the nebulised
water outlet nozzle (4)
• The humidifier is equipped with a water level
sensor. When the water level in the container
goes below minimum level, the nebulisation
circuit switches off automatically (stand-by
function) to prevent damage to the transdu-
cer, while the unit fan will remain in normal
operation.
Warning!!
Never add any salt, aromatic oils or anything
else to the water contained in the tank, as the
appliance could be damaged permanently.
Never direct the nebulised water flow towards
furniture, curtains or electrical appliances or
anything else that is sensitive to water or hu-
midity.
Always switch the appliance off and discon-
nect it from the mains when not in use or left
unattended.

SAFETY AND MAINTENANCE

Warning!!
Before starting any cleaning/maintenance
operations on the appliance, turn the on/off
switch (2) to O - OFF and disconnect the AC/
DC mains adaptor plug from the mains socket
to prevent the risk of electric shocks.
Daily cleaning:
In order to avoid/reduce the formation of bac-
teria or scale residues, it is necessary to clean
the appliance daily, as indicated below:
• Lift the humidifier nebulising unit (transdu-
cer) (6) off the water tank (5) using the han-
dle grooves (8).
• Empty all water residue from the water tank
(5).
• Fill the water tank (5) with cold boiled drin-
king water.
• Rinse several times, taking care to pour out
all the water.
• After draining all the water, dry thoroughly
with a dry cloth, wiping it carefully over the
nebulising unit (transducer) (6) as well.
• In the case where the appliance will not be
used, after the daily cleaning procedure, dry
all parts immediately and then store it away.
Warning!!
• Never clean the water tank (5) with abra-
sive products, alcohol, solvents or similar
products: these products could damage the
water tank (5).
• Never place the appliance under running
water
• Do not wet the electric power cable or air
vent.
14