Machine Information; Technical Specifications - VONROC TS501AC Bersetzung Der Originalbetriebsanleitung

• Never release the workpiece before it has
been completely pushed through the saw.
• Always adjust the guide parallel to the saw
blade.
• Never remove the saw protection.
36. Before you continue sawing, ensure that you
are standing firmly and that your hands are in
the required position.
37. Never use thinners to clean the machine. Only
use a damp cloth for cleaning.
38. Do not use saw blades which are damaged or
deformed.
39. Replace table insert when worn.
40. Only use saw blades specified by the manufac-
turer that are intended for working with wood or
similar materials according to EN847-1.
41. Take care that the selection of the saw blade
depends on the material to be cut.
42. Connect tabelsaws to a dust-collecting device
when sawing.
43. Use and correct adjustment of the riving knife
44. Use and correct adjustment of the upper saw
blade quard.
45. Take care when slotting.
Make sure, when changing the saw blade, the
blade width is not smaller and the main blade
thickness of the saw blade is not greater than the
thickness of the riving knife.
Wear personal protective equipment, these could
include:
• Hearing protection to reduce the risk of hearing
loss
• Eye protection
• Inhale respiratory protection to reduce the risk
of harmful dust
• Gloves when handling the blades and rough
materials (recommendation, saw blades, are
whenever practicable, carried in a container)
Warning! Do not use HSS blades.
• Insert the push stick in its holder when not in use.
• Use a push stick or a push block to guide the
workpiece.
Warning! Do not use the saw for rebating or
grooving.
• Only use saw blades, whose maximum speed is
WWW.VONROC.COM
at least the speed indicated on the saw and is
suitable for the material to be cut.
• During the transport, the upper part of the saw
blade has to be covered, by the guard.
Switch off the machine immediately when you
discover:
• A defective mains plug or mains lead.
• A defective switch.
• Overheating of the machine.
• Smoke or odeur caused by scorched insulation.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use an extension
2
cable reel, always fully unroll the cable.
Power supply
• The motor is fitted with an overload switch. If
the table saw overloads, the overload switch
switches the equipment off automatically to
protect the table saw from overheating. If the
overload switch triggers, switch off the table
saw using the ON/OFF switch (8) and wait until
the table saw cools down. Then press the ON/
OFF switch (8) and restart the table saw.

2. MACHINE INFORMATION

Intended use
This power tool is intended as a stationary
machine for making straight lengthways and
crossways cuts in hard and soft wood free from
foreign bodies such as nails, screws and mortar.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power input
No load speed
Bevel angles
TS501AC
220-240V~
50 Hz
1500W
5000/min
0° <> +45°
11
EN