Specific Safety Instructions - VONROC TS501AC Bersetzung Der Originalbetriebsanleitung

ged or modified. Damaged or modified batteries
may exhibit unpredictable behaviour resulting
in fire, explosion or risk of injury.
f) Do not expose a battery pack or tool to fire
or excessive temperature. Exposure to fire or
temperature above 130 °C may cause explo-
sion. NOTE The temperature „130 °C" can be
replaced by the temperature „265 °F".
g) Follow all charging instructions and do not
charge the battery pack or tool outside the
temperature range specified in the instructi-
ons. Charging improperly or at temperatures
outside the specified range may damage the
battery and increase the risk of fire.
6) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.

SPECIFIC SAFETY INSTRUCTIONS

ATTENTION! When using electric tools to protect
against electric shock, injury and fire the following
basic safety measures must be observed. Make
sure to read all of these instructions before you
use this power tool, keep the safety booklet and
preserve it well for later reference.
1. Always keep your workplace clean and tidy.
• An untidy workplace can lead to unwanted
accidents.
2. Consider environmental influences.
• Do not expose the power tool to rain.
• Do not use the power tool in a damp or wet
environment.
• Make sure that your working space has suffi-
cient lighting.
• Do not use the power tool in areas where there
is a fire or explosive hazard.
3. To protect yourself from an electric shock.
• Avoid body contact with grounded parts (e.g.
pipes, radiators, electric stoves, refrigerators
etc.).
4. Keep other people away
• Keep other people away especially children, do
not let them touch your power tool or cable and
keep the children away from your working area.
WWW.VONROC.COM
5. Store the unused power tools safely.
• Unused power tools should be locked up or
stored in a place that is dry and out of reach of
children.
6. Do not overload your power tool.
• You work better and safer in the specified po-
wer range.
7. Use the correct power tool.
• Do not use low-power machines for heavy work
• Do not use the power tool for purposes that
they are not intended for. For example you can-
not cut tree limbs or a log of wood using a hand
saw.
8. Wear suitable clothing.
• Do not wear loose clothing or jewelry; they can
be caught in the moving parts.
• When working outdoors non-skid footwear is
recommended.
• For long hair, wear a hairnet.
9. Use protective equipment.
• Wear protective goggles
• When doing work that generates dust, use a
breathing mask.
10. Connect the vacuum device
• If connection to the vacuum and catcher are
available then you know that these are connec-
ted and properly used.
11. Do not use the cable for purposes that it is not
intended for.
• Do not use the cable to the connector to pull it
out of the socket. Protect the cable from heat,
oil and sharp edges.
12. Secure the power tool.
• Use clamps or a vice to hold the power tool. It is
safer than holding it with your hand.
13. Avoid an abnormal posture.
• It ensures stability and keeps you balanced at
all times.
14. Keep and maintain tools with care.
• Keep the cutting tools sharp and clean, this
ensures that you work better and that it is as
safe as possible.
• Follow the lubricating and tool changing in-
structions.
• Check the connection cable of the power tool
regularly and let a qualified expert repair any
damages.
• Check the extension cables regularly and re-
place them if they are damaged.
• Keep the handles clean, dry and free of grease
and oil.
EN
9