RICOO S1944 Montageanleitung Seite 11

5b. For displays with curved back
M-D
M-E
M-G
M-H
M-I
6. Preparation of the front plate
Mount two plastic washers and a screw nut, which were removed in step 1, on the top screw of the front
panel, but do not tighten. Between the two plastic washers should remain about 5mm distance.
And the bottom screw provided with a plastic washer (from step 1).
M-D
M-D
M-E
M-E
M-C
M-G M-G M-G
M-H
M-H
M-I
M-F
M-F M-F
M-G
M-G
M-G
M-H
M-I
M-I
5mm
7. Hooking the display onto wall mount
Insert the display along with front panel from above. Insert the top screw on
the front panel into the recess provided on the wall mount.
Note: The front panel holder must be located between the two plastic
washers!
Next put on the bottom screws a plastic washer and a nut.
Align the display with a bubble level and tighten all three screws nuts at medium strength.