Compak K-3 Elite Bedienungshandbuch Seite 23

• Disconnect the machine from the power supply.
• Do not submerge the machine in water.
We recommend the use of cleaning tablets to remove excess grounds.
9.2. Cleaning of the coffee bean hopper
Before cleaning, make sure that there are no beans left in the hopper (2).
Loosen by hand the setting roller (5) and remove the coffee bean hopper (2) from the
grind regulator (6) as in Fig.1 and clean it with a damp cloth or soap and water to eliminate
the oil residues from the coffee, washing it carefully and then drying.
Put the hopper back on the grind regulator (6) and adjust the setting roller (5) by hand.
9.3. Cleaning the ground coffee deposit
To clean the ground coffee holder, first empty all the coffee inside it. Remove the ground
coffee dispenser lid (8) and clean the inside, using a small brush.
9.4. Exterior cleaning
To clean the exterior, use a brush or a cloth dampened with a little bit of soap and water.
NOTE: Never use damp clothes to clean the coffee deposit. Conserve the brush in
a protected place and only use it to clean the grinder to avoid it being contaminated
from other substances. Not following these instructions could affect the taste and
aroma of the coffee.
10
Maintenance
10.1. General warnings
Before performing any type of maintenance work, the following indications
should be taken into consideration:
•Always turn off the machine using the On-Off switch (14 model K-3 Elite -10
model K-3Touch).
• Disconnect the machine from the power supply.
In the event of a breakdown or malfunction, turn the machine off. Do not try to
repair it or intervene directly. Please call your local technical service.
NOTE: Failure to respect this warning could endanger the safety of both the
machine and user.