Test Your Boat In Water; Tips For Controlling; Motor Care - Modster Vector SR48 Brushless Betriebsanleitung

Manual - Vector SR48 Brushless

Test your boat in water

1. Carefully place the boat in water.
2. Operate the boat at slow speed near the shoreline. Avoid objects in water at all time.
3. Once you are comfortable at slow speed, operate the boat farther from the shoreside.
4. Bring the boat back when you notice it starts to run at low speed even when you pull up
throttle to max.
5. Do not use the boat in saltwater . high risk of corrosion.
Tip: If you are using too much steering trim on your transmitter to make the boat drive
straight, return the trim to neutral and mechanically center the rudder. To do this, loosen the
knob from the rudder horn, adjust the knob to a proper position linking to pushrod, make sure
ruder is centered.

Tips for Controlling

Keep away from...
• Watercrafts
• stationary object
• waves and other rapidly moving water
• wildlife
• floating debris or overhanging trees
• Avoid boating in areas where there are many peoples (swimming- or fishing areas)
• Consult local laws and ordinances before choosing a location to operate.
• Maximum speeds are only achieved when the water conditions are smooth and there is
little wind. A sharp turn, wind or waves can turn over a boat when it is moving quickly.
• When running your boat fo the first time, we recommend calm wind and water conditions
so that you can learn how the boat responds to your control.
• When making turns, decrease the throttle in order to drecrease speed and probability of
flipping the boat over.
Notice: When running at full speed in choppy waters, the propeller may exit and re-enter the
water repeatedly and very quickly, subjecting the propeller to some strees. Frequent stress
may damage the propeller.
Caution: Never retrieve your boat from the water in extreme temperatures or without
supervision

Motor Care

Prolong motor life by preventing overheating conditions.
Undue motor wear results from...
• frequent turn, stops and starts
• pushing objects
• boating in rough or vegetation
• boating continuously at high speed
Over-temperature protection is installed on the ESC to prevent circuit damage, but cannot
protect the motor from pushing against heavy resistance.
30 www.modster.at