Use Precautions - air&me Orain Bedienungsanleitung

COMPONENTS (SEE PAGE 2)
Air inlet
1
Feet
2
Pre-filter
3
Filter handle
4
AC power connector
5
Indicator
6
Power button
7
Air outlet
8

USE PRECAUTIONS

• Make sure that the product is placed on a dry flat surface.
• Leave at least 50cm behind, around and in front of the appliance.
• Make sure the removable filter and the tank are properly positioned and pushed in.
• Do not remove the float from the tank because it will prevent the appliance from starting.
OPERATING INSTRUCTIONS
1. Insert the plug into a mains socket.
2. Press the power button on the back on the product to start the machine. The indicator turn
in green light.
3. The product runs automatically at speed 1.
4. Press a second time to activate the speed 2.
5. Press the power button again to turn off.
The light indicator is around the power button:
– the light is green : the product runs normaly.
– the light is yellow : the tank is full or poorly engaged.
AUTO DEFROST FUNCTION
The usage temperature of the dehumidifier is from 5°C to 50°C. It's important to noticed that
when this function starts the efficiency is reduced. For optimal use make sure you have a
temperature between 15°C and 35°C.
12
Water tank
9
Pump connector hole
10
Water tank handle
11
Drainage rubber plug
12
Water level window
13
Top buckle
14
Convex top
15
Floater
16
WATER TANK DETECTION
The dehumidifier will stop running when the water tank is pulled out, and the indicator will
turn yellow. When the water tank is reset, the dehumidifier will run again, the indicator will turn
green.
EMPTYING THE TANK (SEE PAGE 3)
When the tank is full, the indicator will turn yellow and the dehumidifier stops running. The
dehumidifier will run again after filling the tank and resetting.
Empty the tank :
Pull the tank with the handle.
1
Empty the tank through the hole provided for this purpose.
2
Replace the tank and press the power button.
3
CONTINUOUS DRAINAGE (SEE PAGE 3)
Take out the rubber plug of the continuous drain outlet place on the back of the water tank.
1
Plug the drainage hose (diameter: 8mm). Put the end of the hose in a floor sewage disposal.
2
The product will run automatically in continuous drainage. Be aware that the hose is not fold and
the water could flowing easily with gravity
LIFT PUMP CONNECTION
Orain have a lift pump hole evacuation (none included):
Open the tank, put the pump in it.
1
Place the hose and the power cord outside thanks to the hole evacuation.
2
Replace the convex top before pushing the tank into the product.
3
13