Air Ducts - STIEBEL ELTRON LWZ 130 Bedienung Und Installation

INsTALLATIoN
Installation
1
2
3
1 Vent hose
2 Hose bend
3 Vent hose
f Push the supplied hose bend onto the appliance condensate f
drain connection. Secure the hose bend with a cable tie.
f Push the other end of the hose bend onto the connection on f
the float module. Secure the hose bend with a cable tie.
f Connect the supplied vent hose to the float module. The con- f
nection on the float module is above the condensate outlet.
f Undo the cable tie that has sealed the vent hose which comes f
out of the appliance.
f Push the vent hoses into one another. f
f Connect a condensate hose to the condensate outlet of the f
condensate pump and route it into a drain. In order for the
condensate pump not to run dry, the condensate hose behind
the pump must not route directly downwards.
f Connect the power supply of the condensate pump. f
Colour
GN
WH
BK
www.stiebel-eltron.com
326794-40317-9268_LWZ_130_de_en.indb 37
Ground
Neutral
Phase

10.3 Air ducts

Material losses
!
Never link cooker hoods to the ventilation system.
Material losses
!
During installation, ensure that no metal swarf enters
the pipework. However, should this occur, remove this
debris, otherwise the fans may be damaged.
Install the air ducts using materials that can be obtained from us
or with commercially available folded spiral-seam tubes.
10.3.1 Connecting air ducts to the appliance
You can connect air ducts with two different diameters to the
appliance.
Air ducts with diameter DN 125
f Push the air duct onto the air connection. f
f Secure the air duct at the appliance air duct connection with f
self-adhesive aluminium sealing tape.
Optional : Air ducts with diameter DN 150
You can obtain DN 150 air duct connectors from us as accessories.
f Remove the air duct connectors mounted in the delivered f
condition by undoing the screws.
f Screw the new air duct connectors onto the appliance. f
10.3.2 External wall ducts
Install the outdoor air intake into the building at a location where
contamination (dust, soot, odours, flue gas, exhaust air) is as low
as possible.
When installing external wall ducts, prevent any short circuit be-
tween the air intake and the air discharge.
LWZ 130 | 37
26.10.2017 18:38:22