Lubrication; Connecting To A Compressed Air Source - Parkside PDSS 310 B5 Originalbetriebsanleitung

Lubrication

WARNING!
► Find out about any health hazards posed by the
oil you are using by reading the safety data
sheet provided by the respective manufacturer .
► Avoid eye and skin contact with lubricants .
NOTE
► Regular lubrication is particularly important to
avoid friction and corrosion damage .
We recommend using a suitable special oil
for compressed air tools (e .g . Liqui Moly
compressor oil) .
♦ First screw the 1/4" threaded nipple t onto
the 1/4" internal thread connection r of the
mini compressed air oiler 8 .
♦ Then fill the mini compressed air oiler 8 with
3–5 drops of special compressed air oil .
To do this, undo the Phillips screw of the oil filler
opening e attached to the mini compressed
air oiler 8 . Use the supplied oil bottle 0 to
drip oil into the oil filler opening .
NOTE
► As a treatment stage downstream of the
pressure reducer, a mist oiler lubricates the
compressed air unit continuously and optimally .
A mist oiler adds fine drops of oil to the air
flowing through the tool and therefore
guarantees regular lubrication .
♦ Now screw the 1/4" threaded connection w of
the mini compressed air oiler 8 into the 1/4"
internal thread connection q of the impact
wrench .
■ 10 │ GB │ CY
Connecting to a compressed air
source
NOTE
► Before connecting the compressed air source
–
the correct working pressure (6 .3 bar) must
be fully reached, and
–
you must ensure that the trigger is in the
uppermost position .
► The optimum pressure is 6 .3 bar . The maxi-
mum torque cannot be achieved with a pres-
sure of only 5 bar or an insufficient air volume .
► Use only connecting hoses with an internal
diameter of at least 9 mm .
► The connection to the compressed air source
is made using a flexible compressed air hose
with a quick coupler .
♦ Now press the quick coupling of the compressed
air hose (not supplied) onto the compressed air
connector z . The connection locks automati-
cally .
♦ Now connect the other end of the compressed
air hose to the (filter) pressure reducer on the
compressor .
CAUTION!
► Ensure that the compressed air hose is firmly
attached . A loose hose can thrash about
uncontrollably, causing serious danger . Like-
wise, ensure that the two screw connections
between the coupling piece and the tool are
firmly seated .
♦ The compressed air source must be equipped
with a pressure reducer so that you can regu-
late the air pressure .
PDSS 310 B5