Hafele DFT V2 Betriebsanleitung Seite 15

8. Operation
8.1 Operation (latch bolt
lock operation)
8.2 Operation (dead bolt
lock operation)
9. Changing the parameters
9.1 Setting the opening
period
9.2 Setting the delay
period
9.3 Activating the dead
bolt lock operation
9.4 Fallenschloss-betrieb
aktivieren
• Latch bolt lock operation = factory setting.
• An authorised user key is required for the operation.
For step-by-step instructions „Operation (latch bolt lock operation)"
see illustrations starting on page 47.
• An authorised user key is required for the operation.
For step-by-step instructions „Operation (dead bolt lock operation)"
see illustrations starting on page 48.
• The dead bolt lock operation is set according to chapter „9. Changing the parameters"
The special keys required for changing the parameters are not included in the scope of delivery
and must be ordered separately. Contact the manufacturer for ordering.
The special key „Open Time #74" must be ordered to set the opening period.
For step-by-step instructions „Setting the opening period" see illustrations
starting on page 49.
The special key „Output Delay #81" must be ordered to set the delay period.
For step-by-step instructions „Setting the delay period" see illustrations
starting on page 50.
The jumper must be removed on connections 3 and 4 of the DFT to activate the dead bolt
lock operation and a simple reset must be performed.
For step-by-step instructions „Activating the dead bolt lock operation"
see illustrations starting on page 51.
The jumper must be reset on connections 3 and 4 of the DFT to activate the latch bolt lock
operation and a simple reset must be performed.
For step-by-step instructions „Activating the latch bolt lock operation"
see illustrations starting on page 52.
15