Specifications - Makita 6402 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Low
1-2. High
1-3. Speed control screw
1-4. Switch trigger
1-5. Lock button

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling in wood, metal and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model DP4700
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Model DP4700
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
2-1. Reversing switch lever
3-1. Reversing switch lever
4-1. Side grip
5-1. Tighten
5-2. Chuck key
Model
Steel
Wood
-1
)
Overall length
Net weight
Safety class
) : 86 dB (A)
pA
) : 97 dB (A)
WA
2
) : 2.5 m/s or less
h,D
2
6402
10 mm
21 mm
0 - 1,200
264 mm
1.5 kg
ENE032-1
The declared vibration emission value has been
•
measured in accordance with the standard test
ENF002-2
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
ENG905-1
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
ENG900-1
Makita declares that the following Machine(s):
Designation of Machine:
Drill
Model No./ Type: DP4700
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
3
6-1. Tighten
6-2. Sleeve
6-3. Ring
DP4700
13 mm
36 mm
0 - 550
275 mm
2.2 kg
/II
ENG901-1
ENH101-17