Specifications - Makita 9566CR Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Slide switch
3-1. Indication lamp (speed adjusting
dial)
4-1. Indication lamp
5-1. Speed adjusting dial
7-1. Wheel guard
7-2. Bearing box
7-3. Screw
7-4. Lever

SPECIFICATIONS

Depressed center wheel diameter
Rated speed (n) / No load speed (n
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Model 9566CR
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
8-1. Screw
9-1. Lock nut
9-2. Depressed center grinding wheel
9-3. Inner flange
10-1. Lock nut wrench
10-2. Shaft lock
11-1. Marking A
12-1. Marking B
13-1. Marking C
14-1. Pin
Model
Spindle thread
)
o
Overall length
Net weight
Safety class
) : 86 dB(A)
pA
) : 97 dB(A)
WA
2
) : 6.5 m/s
h,AG
2
9566CR
150 mm
10000 min
299 mm
2.3 kg
ENE048-1
Model 9566CVR
Work mode : surface grinding
Vibration emission (a
ENF002-1
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG905-1
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENG900-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
14-2. Vent
16-1. Lock nut
16-2. Abrasive cut-off wheel/diamond
wheel
16-3. Inner flange
16-4. Wheel guard for abrasive cut-off
wheel/diamond wheel
17-1. Exhaust vent
17-2. Inhalation vent
M14
-1
/II
) : 7.0 m/s
h,AG
2
9566CVR
150 mm
M14
-1
4,000 - 10,000 min
299 mm
2.3 kg
2
ENG902-1