Angle Calculation; Transponder Control - Megasat HD 5 Combo Bedienungsanleitung

3. Main Menu

3.1.7 Angle calculation

Satellite
Displays the current satellite. Use the
ge the satellite or press OK to open the satellite list.
Degree of longitude
Enter the longitude using the number keys.
Location
Use the
t u
Degree of latitude
Enter the latitude with the number keys.
Hemisphere
Use the
t u
If you are above the Equator, select North.
If you are below the equator, select South.
Calculation
Press OK to start the angle calculation.
Azimuth
Shows the horizontal angle from the geographic north
direction
Elevation angle
Displays the vertical angle (elevation) of the dish.
14
t u buttons to chan-
buttons to switch between East and West.
buttons to change between north and south.
ENGLISH
3. Main Menu

3.1.8 Transponder control

The transponder control allows you to simultaneously evaluate 4 selected transponders.
At a glance you can see the signal strength and quality of the individual transponders:
1. Use the t u buttons to change to the desired display.
2. Press OK to enter the transponder list.
3. Use the pq buttons to select a transponder and confirm with OK.
4. If necessary, repeat the operation with all 4 columns.
5. This function is very good to check all 4 levels at the same time. Make sure that 4
different TPs are selected (HH, VH, HL, VL) and you can control all four transponder
levels at a glance. Furthermore, individual lines can be determined with this function.
Note:
Press the SAT button to select another satellite.
ENGLISH
15