Releasing The Lashing Strap - Powerfix Profi HG01827A Bedienungs- Und Sicherheitshinweise

Calculate the number of lashing devices according to EN 12195-1. Only
lashing systems labelled for lashing down with STF (standard tension
force) may be used for friction lashing.
Place the lashing strap around the load
¾
Open the ratchet handle
¾
position so that the webbing
Insert the webbing
¾
Carefully pull it through the slotted shaft
snug against the load.
Tighten the lashing strap by moving the handle
¾
backwards and forwards (see Fig. A I - III). Tighten the lashing strap
until you have obtained the tension you wish to have.
Note:
Make sure that webbing
maximum of 3 times around the slotted shaft
Bring the ratchet handle
¾
load is now secure.
˜ Releasing the lashing strap
CAUTION! Check before releasing the strap that the load is stable.
Make sure that the load is stable even without the lashing strap and
that it cannot fall down.
16 GB
and place the slotted shaft
1
can be inserted into it (see Fig. A III).
4
into the slotted shaft
4
4
into the basic position (see Fig. A I). The
1
of the ratchet.
3
until the webbing
3
of the ratchet
1
is wound at least 1.5 times to a
.
3
into the
3
lies
4