Wiring Connection - Kenwood KMM-106 Bedienungsanleitung

Installation/Connection

Wiring connection

If your car does not have an ISO terminal:
We recommend installing the unit with a commercially available
custom wiring harness specific for your car and leave this job to
professionals for your safety. Consult your car audio dealer.
Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring harness as
illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function (for ISO connectors)
A4 Yellow : Battery
A5 Blue/White*1 : Power control
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
Purple ]
B1
: Rear speaker (right)
Purple/black [
B2
B3 Gray ]
: Front speaker (right)
B4 Gray/black [
White ]
B5
: Front speaker (left)
White/black [
B6
Green ]
B7
: Rear speaker (left)
Green/black [
B8
Fuse (10 A)
Yellow (Battery wire)
Ignition wire (Red)
Unit
Red (Ignition wire)
Battery wire (Yellow)
Red (A7)
Yellow (A4)
When connecting to an external amplifier to the output terminals of this unit, firmly connect the
ground wire of the amplifier to the car's chassis to avoid damaging the unit.
Output terminals
If no connections are made, do not let the wire come out from the tab.
Light blue/yellow
STEERING WHEEL
(Steering remote control
REMOTE CONT
wire)
Blue/White*2
ANT CONT
(Power control wire/
Antenna control wire)
Brown
(Mute control wire)
NOTE: Total output for Blue/White wire
ISO connectors
(*1) + (*2) is 12 V
Antenna terminal
REMOTE INPUT
To the steering wheel remote control
adapter
To the power control terminal when
using the optional power amplifier or
P. CONT to the antenna control terminal in the
vehicle
To the terminal that is grounded when the
telephone rings or during conversation
MUTE
(Page 17)
(To connect the Kenwood navigation
system, refer your navigation manual)
350 mA
ENGLISH
15