Novamatic EK1017RE Benutzerhandbuch Seite 13

13
Problem
The compressor does not
start immediately after press-
ing the FastFreeze,Shopping
or after changing the temper-
ature.
Water flows on the rear plate
of the refrigerator.
Water flows into the refrigera-
tor.
Water flows on the floor.
Temperature cannot be set.
Temperature cannot be set.
Temperature cannot be set.
Possible cause
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
During the automatic defrost-
ing process, frost melts on
the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The FastFreeze or Shopping
function is switched on.
The FastFreeze function is
switched on.
The Shopping function is
switched on.
Solution
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
This is correct.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze
function" or "Shopping func-
tion".
Switch off FastFreeze man-
ually, or wait until the function
resets automatically to set
the temperature. Refer to
"FastFreeze function"
Switch off Shopping manual-
ly, or wait until the function
resets automatically to set
the temperature. Refer to
"Shopping function".