Commissioning - Auriol IAN 321597_1901 Bedienungs- Und Sicherheitshinweise

Rain gauge:
– Transmits rainfall quantity to the weather station
on 434 MHz frequency
– Easy to stand or mount with screws on an even
surface
– It is best to stand or mount the rain gauge in an
areas which are not protected from rain.
CAUTION!
Comply with the following safety instruc-
tions when using the wind gauge and
rain gauge:
– Never immerse the measuring products in water
or other liquids
– Never place the measuring products in ovens
or microwaves
– Never expose the measuring products to tem-
peratures below –20 °C or above 60 °C
– Keep the measuring product away from
chemicals

10. Commissioning

WARNING!
Familiarize yourself with the weather station, wind
gauge and rain gauge before assembly. The operating
instructions are easier to understand if you are hold-
ing the products in your hand while reading them.
Setting up the weather station:
The weather station comes with a pre-assembled
stand, making it easy to set up the weather station
in the desired position.
Note: Remove the protection foil from the display
(weather station) before use.
Note: Remove all packing material before use.
30 GB/IE
1
ø 5 mm
Weather station – wall mounting:
1. Mark the drill holes (horizontal distance approxi-
mately 11.3 cm) for the weather station and
make sure that no electrical or water lines will be
damaged before drilling the holes (ø 5 mm).
2. Push the dowel into the drilled hole until it is
flush with the wall.
3. Screw the supplied screws into the dowels,
allowing them to protrude slightly for the weather
station to be hung on.
The pre-assembled stand can be removed from the
weather station. Fold the stand downwards and pull
it out of the slot. To attach again, follow the same
procedure in reverse order.
Hanger
PH0 0.5 x 3
5 mm
10 mm