Sanding Close To The Edge; Operation; Switching On; Switching Off - Parkside PWBS 180 A1 Betriebsanleitung

♦ To prolong the service life of the accessory tool,
ensure that you apply even pressure.
♦ Use of excessive pressure does not lead to a
greater removal rate, but rather to increased
wear of the accessory tool.
♦ Lift the appliance off the working surface.
♦ For internal extraction:
Let the power tool run for a few more seconds
to remove the remaining dust from the suction
hose .

Sanding close to the edge

If you are sanding close to the edge, you can
remove a hood segment
suction hood . This means that the accessory
tool you are using is closer to floor, wall and ceil-
ing edges as well as existing installations such as
pipes, and the adjacent surfaces can be precisely
machined.
Expect dust to develop during this work, as the pro-
tective and suction hood
♦ Pull the hood segment
protective and suction hood
♦ Work the surfaces close to the edge.
♦ Push the hood segment
hood until it locks into place.

Operation

■ Tool direction of rotation!

Switching on

♦ To switch on the appliance, slide the On/Off
switch forwards.
To lock the On/Off switch
switch down at the front until it clicks
into place.
Switching off
PWBS 180 A1
of the protective and
is no longer closed off.
forwards out of the
.
back into the suction
, press the On/Off
♦ To switch off the power tool, let go of the On/
Off switch . If it is locked, press the rear end
of the On/Off switch

Setting the rotational speed

Before starting work, set the speed to suit the
application. Use a low speed for coarse sanding;
increase the speed for fine sanding.
■ Adjust the speed by pressing the buttons
♦ Press the + button
♦ Press the – button
NOTE
► The accessory tool rotates after switching off.
Wait until the accessory tool has come to a
standstill before putting down the appliance.

Maintenance and cleaning

WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work on the appliance.
■ The appliance is maintenance-free.
■ Do not use any sharp objects for cleaning
the appliance. Do not allow any liquids to get
into the appliance. The appliance could be
damaged.
■ Clean the appliance regularly, preferably imme-
diately after completion of the work.
■ Clean the housing with a dry cloth – do not use pet-
rol, solvents or cleaners that can attack the plastic.
■ Never obstruct the ventilation openings.
■ Remove any adhering swarf with a brush.
NOTE
► Unlisted replacement parts (such as carbon
brushes, switch) can be ordered via our
service hotline.

Emptying the dust bag

To ensure optimum dust extraction, empty the dust
bag regularly.
♦ Open the zip on the dust bag
♦ Shake out the dust bag
container.
and then release it.
.
to increase the speed.
to decrease the speed.
.
over a suitable waste
GB │ IE │
27 ■