Technical Specifications; General Power Tool Safety Warnings - Parkside PWBS 180 A1 Betriebsanleitung

Technical specifications
Rated voltage:
Rated power
consumption:
Rated speed:
Rated capacity:
Thread size:
Protection class:
Noise and vibration data:
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level of
the power tool is typically as follows:
Noise emission value:
Sound pressure level: L
Uncertainty:
Sound power level:
Uncertainty:
Wear ear muffs!
Total vibration value:
Surface sanding:
Uncertainty:
PWBS 180 A1
230 V ∼ 50 Hz (AC)
1050 W
n 410−1900 rpm
Ø 180 mm
M14
II / (double insulation)
= 94 dB(A)
PA
K = 3 dB
L = 105 dB(A)
WA
K = 3 dB
a = 16.4 m/s 2
h, AG
K = 1.5 m/s 2
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for appliance comparisons. The
specified vibration emission value can also be
used to make an initial exposure estimate.
WARNING!
► The vibration level varies depending on the
use of the power tool and may be higher
than the value specified in these instructions
in some cases. Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration. Try to keep the vibration
loads as low as possible. Measures to reduce
the vibration load are, e.g. wearing gloves
and limiting the working time. Wherein all
states of operation must be included (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
General power tool
safety warnings
WARNING!
► Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
GB │ IE │
19 ■