Werbung
K40945 - K40946 - K40955 - K40956
13) After saving, the device shows an initial
image
14) Tap once on the image to enable the
connection and enter "preview" mode.
As soon as the connection has been
established, the App prompts you to
change the password, switching from
the default password to the password
customised by the user. For security
reasons, the password must comprise a
series of numbers of between 4 and 16
digits. Tap once on "Confirm" to proceed
15) Proceed by entering a new password
and confirming it. Keep a note of the
password you have just set. Should you
wish to connect the monitor to another
smartphone, you will have to use the
same password.
16) Once you have saved the new password,
the connection between the App and the
monitor proves enabled.
17) In the "Devices" section, you will there-
fore see the connection to the device
referred to as "home" as enabled, as
shown below:
18) Note that when you enter the "Settings"
section of the App you can define the
following functions for all connected
devices
EN
Sound: ringtone enabling
Vibration: vibration enabling
Auto-rotate: image auto-rotate enabling
Video channel select: automatic or manual
selection
Preview time: maximum communication
duration setting (from 60s to 420s).
Information: information on the App
19) In the "Settings" section relating to
the connected monitor, the following
functions are available relating to the
individual device connected:
33
Werbung
