Mounting Convection Fan - RIKA DOMO BACK MultiAir Montageanleitung

Mounting Convection Fan

Depending on the desired option cut off the two upper markers for
one fan, for the second fan in addition the two bottom markers.
Undo the marked screws of the stove and remove the heat shield.
The heat shield will no longer be needed after disassembly and can
therefore be discarded.
Screw on the fan housing with 3 screws.
If you install both convection fans, remove now the lower round cover
and fit here the second fan housing.
# 8
Note
All cables must be protected from heat. Improper installation can
damage your stove and void your warranty.
Run the cable further through the recess at the heat deflector.
#10
#10