Dimensions; Convection Air Connection; General Information; Disassembly Rear Panels - RIKA DOMO BACK MultiAir Montageanleitung

Dimensions

Convection Air Connection

K - Ø Diameter
K1 - H Connection Height
K1 - S Side Distance
K2 - H Connection Height
K2 - S Side Distance
Combustion Air Connection
F - Ø Diameter
F - H Connection Height
F - S Side Distance
Note
Only work on the unit when the mains plug has been disconnected
and the stove has cooled down completely.
Note
During assembly / dismantling do not allow objects (screws etc.) to
fall into the pellet container – they can block the screw conveyor
and damage the stove.
Note
During any conversion work, take particular care of your fingers
and any panels and stove attachments. Select soft bases to
prevent scratches to your living space furniture and stove panels.

General information

Note the regional specific fire safety regulations and clarify the
Q
connection situation with the competent authority.
The convection air amount and temperature is designed for
Q
heating one or, if two fans are installed, two additional rooms.
The max. temperature of the convection air is 180° C at the air
Q
outlet.
The convection air duct should be as short as possible.
Q
Keep the number of deflections as small as possible.
Q
Note
Please pay attention to the national and country-specific building
and fire regulations when connecting the convection air pipes.
Installation and assembly must be performed by a trained
specialist only.
The option MultiAir is basically only with the lower flue pipe
connections (rear and side) possible. If only one convection fan is
mounted, it can be combined with the increased rear connection.

Disassembly rear panels

Remove the handle of the flue gas flap.
Loosen the 4 screws on the rear panel. The rear panel tilts backwards,
then you can lift it off.
[mm] 100
[cm] 82
[cm] 12
[cm] 50
[cm] 15
[mm] 60
[cm] 38
[cm] 18
#5
#3
#25
|23
22