Fm Mode / Aux-In Mode / Optical In Mode; Optical In Mode - Revo SuperSystem Bedienungsanleitung

FM RADIO MODE
FM SETTINGS
Press the button to access the FM MODE MENU. From here you can
set some FM preferences such as SCAN SETTING and AUDIO SETTING.
SCAN SETTING allows you to decide whether the radio should stop
scanning only when it fi nds a station with a strong signal.
AUDIO SETTING gives you the option of listening to a station in mono,
should the signal strength not be suffi ciently strong to allow stereo
reception.
AUX IN MODE
AUX IN MODE allows you to play audio from an external source (such
as an MP3 player) through your SUPERSYSTEM. To do so, connect your
external audio source to the 3.5mm AUX IN connector on the rear of
SUPERSYSTEM.
Before connecting, Turn the volume down low on both SUPERSYSTEM
and, if adjustable, the external device.
To enter AUX IN MODE, press the
press the button until the Aux In intro screen is displayed.
Adjust the volume of SUPERSYSTEM and, if necessary, the external
audio device as required.

OPTICAL IN MODE

OPTICAL IN MODE allows you to connect a digital audio source
(Television/Set Top Box, Computers/Laptops and CDs players etc.
might offer this type of output). To connect you will require a
"TOSLINK" cable plugged in to the external source and connected to
the OPT IN connector on the rear of SUPERSYSTEM.
To enter OPTICAL IN MODE, press the
or press the button until the Optical In intro screen is displayed.
If applicable we recommend setting the volume to about 80% on
the source and use the volume control of SUPERSYSTEM to set your
desired level.
button on the front panel, or
button on the front panel,
Scan setting
Audio setting
Main menu
Auxi liary Input
Audio in
Aux in
Today's Date :
22/02/15
Opti cal I nput
Optical in
Optical In
Today's Date :
15/10/15
>
15