IBO WQ Betriebsanleitung Seite 12

DECLARATION OF CONFORMITY UE/WE (Moduł A):
1. Submersible pumps: WQ, WQF, WQ PRO, FURIATKA, Furia, KRAKEN, BIG, IP, IP
INOX,Multi IP, Multi IP AUTO, IPC, IPE, IPK, SWQ, SWQ PRO,CTR, ZWQ, MAGNUM, V,
MWQ, KBFU, SN, WQX
2. PHU Dambat, Gawartowa Wola 38, 05-085 KAMPINOS, POLAND, e-mail:
3. This declaration of conformity is issued under the sole responsibility of the manufacturer.
4. Pumps form point 1.
5. Under the Act of 30 August 2002 on the conformity system (Journal of Laws of 2004, No. 204 item
2087) we declare with full responsibility that pumps included in the point 1. to which this declaration
refers to are consistent with the following guidelines of the Council on legal regulations unification in
member states of EC:

MD Nr. 2006/42/WE
Applied standards: EN 809:1998 + A1:2009

LVD Nr. 2014/35/UE
Applied standards: EN 60335-1:2012+AC:2014, EN 60335-2-41:2003+A1:2004+A2:2010

EMC Nr. 2014/30/UE
Applied standards: EN 55014-1:2006+A1：2009+A2:2011, EN 61000-3-2:2014
Gawartowa Wola 23.01.2015
Adam Jastrzębski
POSSIBLE PROBLEMS AT OPERATION AND THEIR SOLUTION:
Symptom:
The
pum does
p not work
12
Possible cause:
Float switch is in the "off" position
Insufficient quantity of water in the
pumping well for rising of the float
switch into the "on" position
The float switch has caught
against something and cannot
change its position to "on"
No electric power supply
The pump is blocked
biuro@dambat.pl
Solution of the problem:
Wait, until the quantity of water in
the pumping well will be sufficient
for automatic turning on of the
pump with the use of float switch.
Check whether the float switch can
move freely.
Check whether electric plug of the
pump is properly put into the electric
socket
Check "fuses" in the electric plug
and next in the house and any kinds
of installation fuses that may turn
off the flow of current from the
network
Check whether there is power
supply in the area of your house –
power supply may be disconnected
by the power company on a larger
area
Disconnect electrical supply from the
pump. After taking out the pump
from the tank, unblock the impeller
of the pump. Before putting the
pump to the tank again, check
whether the impeller rotates without
problems.