Black+Decker BDT555KIT Type 1 Bedienungsanleitung Seite 7

Electrical safety
#
This appliance is double insu-
lated; therefore no earth wire is
required. Always check that the
power supply corresponds to the
voltage on the rating plate.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Electric safety can be further improved
u
by using a highsensitivity 30 mA Re-
sidual Current Device (RCD).
Labels on appliance
The following warning symbols are found on the appliance
along with the date code:
Read the manual prior to operation.
Wear safety glasses or goggles when operating
this appliance.
Wear suitalbe ear protectors when operating this
appliance.
Always remove the plug form the socket before
inspecting a damaged cable. Be careful not to
!
use your srimmer if the cable is damaged.
Beware of flying objects. Keep bystanders away
from the cutting area.
Do not expose the appliance to rain or high
humidity.
Directive 2000/14/EC guaranteed sound power.
Features
This appliance includes some or all of the following features.
1. On/off switch
2. Handle
3. Cable restraint
4. Power inlet
5. Second handle
6. Guard
(Original instructions)
7. Spool housing
8. Head
9. Edge wheel
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting the guard (fig. A & B)
Remove the screw from the guard.
u
Keeping the guard (6) square to the strimmer head (8)
u
slide it into place until the retaining tab clicks into place
(Ensure that the guide rails (10) on the guard (6) are
correctly aligned with the guide rails (11) on the strimmer
head (8). fig. A).
Secure the guard (6) with the screw (12).
u
Warning! Never use the tool unless the guard is properly
fitted.
Attaching the second handle (fig. C)
Press in and hold both of the buttons (13) on the side of
u
the handle.
Slide the second handle (5) in place over the buttons (13).
u
Warning! Ensure that the teeth on the button are correctly
aligned in slots in the handle and that the handle is secure.
Adjusting the position of the secondary handle (fig.
D)
The second handle (5) can be adjusted to provide optimum
balance and comfort.
Press in the button (13) on the left side of the handle.
u
Rotate the second handle (5) into the required position.
u
Release the button (13).
u
Warning! Ensure that the teeth on the button are correctly
aligned in slots in the handle and that the handle is secure.
Adjusting the height of the tool (fig. E)
This tool has a telescopic mechanism, allowing you to set it to
a comfortable height. There are multiple height settings.
To adjust the height setting, proceed as follows:
Disconnect the tool from the supply.
u
Loosen the adjustment collar (14) by turning it clockwise.
u
Gently pull the tube (15) in or out of the handle (2) to the
u
desired height.
Tighten the adjustment collar (14) by turning anti-clock-
u
wise.
Releasing the cutting line
In transit, the cutting line is taped to the spool housing.
Warning! Before assembly, disconnect from the power supply.
Remove the tape holding the cutting line to the spool
u
housing (7).
ENGLISH
7