Connecting The Appliance; Switching On The Appliance; Selecting The Temperature - Gaggenau RW262 Gebrauchsanleitung

Connecting the appliance

After installing the appliance, wait at least ½ hour until
the appliance starts up. During transportation the oil in
the compressor may have flowed into the refrigeration
system.
Before switching on the appliance for the first time, clean
the interior (see Cleaning).
The socket should be freely accessible. Connect the ap
pliance to 220 240 V/50 Hz alternating current via a cor
rectly installed earthed socket. The socket must be fused
with a 10 A fuse or higher.
If the appliance is to be operated in a non European
country, check on the rating plate whether the
indicated voltage and current type correspond
to the values of your mains supply. The rating plate
is located in the refrigerator compartment at the
bottom left hand side. The mains connection cable
may be replaced by an electrician only.
Warning!
!
Never connect the appliance to electronic energy
saver plugs or to power inverters which convert the
direct current to 230 V alternating current (e.g. solar
equipment, power supplies on ships).

Switching on the appliance

Press the main switch, 11. The appliance starts
refrigerating.
At the factory the refrigerator compartment was set to
+10 °C.

Selecting the temperature

The set values can be changed, see Description of
control panel.
11
27